活性炭纤维电极电解法处理墨绿B染料废水

将铁丝缠绕在活性炭纤维(简称ACF)上制成电极,并在阴极鼓入空气,用电解生成的Fenton试剂处理墨绿B染料模拟废水.研究了电压、pH值、温度、空气流量、支持电解质的浓度等因素对染料脱色率的影响.结果表明,pH值越低,温度越高,处理效果越好,气流量的改变对于处理效果影响不大.室温时处理浓度为50mg·L-1的活性染料墨绿B,在实验电压为11V,中性条件下,无水硫酸钠的浓度为20g·L-1,通入空气流量为60L·min-1时,处理60min,色度去除率达到95%左右.55℃时,电解30min色度去除率就达到96%,60min时达到100%.     

Preconcentration and Separation Procedures for the Spectrochemical Determination of Platinum and Palladium

Low concentrations of Pt and Pd in industrial (µgg^–1 level) and environmental samples (ngg^–1 level) together with the complexity of the matrix causing many interferences during the determination of noble metals often require elaboration and application of pre-concentration/matrix separation procedures before detection of the analyte. Different pre-concentration/matrix separation procedures applied prior to the determination of Pt and Pd by atomic spectrometric techniques are reviewed and critically compared taking into account potential interferences. The methods studied are divided into 5 groups including precipitation and coprecipitation, liquid–liquid extraction, solid phase extraction, electrochemical pre-concentration and biosorption. The main analytical problems occuring during sample preparation and storage are discussed.     

普鲁士兰修饰碳黑微电极同时微分伏安法测定多巴胺和抗坏血酸

将含有1.0%普鲁士蓝的碳黑与固体石蜡按2.5∶1(质量比)混合后装入φ0.2mm的石英毛细管中,在其上端插入一铂丝并抛光后即制成普鲁士蓝修饰碳黑微电极.对多巴胺(DA)及抗坏血酸(VC)在此电极上的电化学行为及应用此电极测定两组分的最佳条件进行了研究,在定量测定中采用二次微分线性扫描伏安法.在最佳条件下,DA与VC的峰电流(i″p)分别与各自的浓度保持如下线性关系DA为4.0×10-6～8.0×10-4mol·L-1,VC为6.0×10-5～1.0×10-3mol·L-1;检出限(3σ)依次为2.0×10-6mol·L-1及1.0×10-5mol·L-1.应用此方法分析了3种含DA及VC的混合溶液,测得结果的相对标准偏差(n=8)依次小于2.0%及3.0%,回收率范围依次为96.5%～101.0%及95.0%～102.5%.     

Investigation of the Cu-Zr-Y oxides activity in the carbon black catalytic oxidation by differential thermal analysis and temperature programmed reduction

Different copper/zirconium-yttrium catalysts have been tested in carbon black oxidation reaction. Supported mainly on differential thermal analysis and temperature programmed reduction, two different mechanisms have been proposed to explain the catalytic results. In the absence of copper, it has been shown that Zr³⁺ ions and associated anionic vacancies are responsible to the catalytic enhancement observed in the mixed oxides, oxygen species being activated on these sites. Among mixed zirconia-yttria solids, ZrO₂-5 mol%Y₂O₃ is the most active catalyst. Copper impregnation on these oxides leads to the formation of different copper species. Small particles of CuO in low interaction with the support, induce a catalytic improvement due to the highest reducibility of these species. Moreover, in order to be more efficient, CuO species should have some interactions with the support, since impregnated samples are more active than the simple mechanical mixtures.     

Mononuclear Pt(II) and Pd(II) 1,4-dithiolato complexes. Crystal structures of [Pt((−) DIOS) (PPh3)2] and [Pd(S(CH2) 4S)(Ph2P(CH2) 3PPh2)]. Application in styrene hydroformylation

Addition of 1,4-dithiols to dichloromethane solutions of [PtCl₂(P-P)] (P-P = (PPh₃)₂, Ph₂P(CH₂)₃PPh₂, Phd₂P(CH₂)₄PPh₂; 1,4-dithiols = HS(CH₂)₄SH, (−)DIOSH₂ (2,3-O-isopropylidene-1,4-dithiol-l-threitol), BINASH₂ (1,1′-dinaphthalene-2,2′-dithiol)) in the presence of NEt₃ yielded the mononuclear complexes [Pt(1,4-dithiolato)(P-P)]. Related palladium(II) complexes [Pd(dithiolato)(P-P)] (P-P=Ph₂P(CH₂)₃PPh₂, Ph₂P(CH₂)₄PPh₂; dithiolato = ⁻S(CH₂)₄S⁻, (−)-DIOS) were prepared by the same method. The structure of [Pt((−)DIOS)(PPh₃)₂] and [Pd(S(CH₂)₄S)(Ph₂P(CH₂)₃PPh₂)] complexes was determined by X-ray diffraction methods. Pt—dithiolato—SnC1₂ systems are active in the hydroformylation of styrene. At 100 atm and 125°C [Pt(dithiolate)(P-P)]/SnCl₂ (Pt:Sn = 20) systems provided aldehyde conversion up to 80%.     

The preparation of a new polysiloxane copolymer with glucosylthioureylene groups on the side chains

A new polysiloxane with pendent sugar units was prepared by a two-step method: the preparation of the polysiloxane with amino groups on the side chain and then the copolysiloxane reacted with glucosyl isothiocyanate. All polymers were characterized by FT-IR 1H-NMR, 1H-1H-COSY, 13C-NMR, and DEPT respectively. In the same time, Platinum oxide was found to be a versatile and powerful hydrosilation catalyst in the hydrosilylation reaction of aminotrimethylenepolysiloxanes with heptamethylcyclotetrasiloxane (D₄^H).     

Synthesis and characterization of platinum(II) and (IV) complexes containing hexamethyleneimine ligand: crystal structure of [Pt(hexamethyleneimine)2(cyclobutanedicarboxylato)]·H2O

A series of new platinum(II) and platinum(IV) complexes of the type [Pt^II(HMI)₂X] (where HMI=hexamethyleneimine, X=dichloro, sulfato, 1,1-cyclobutanedicarboxylato [CBDCA], oxalato, methylmalonato, or tatronato) and [Pt^IV(HMI)₂Y₂Cl₂] (where Y=hydroxo, acetato, or chloro) were synthesized and characterized by infrared (IR) spectroscopy, ¹³C and ¹⁹⁵Pt nuclear magnetic resonance (NMR) spectroscopy and elemental analysis. Among the complexes synthesized, [Pt^II(hexamethyleneimine)₂(1,1-cyclobutanedicarboxylato)]·H₂O was examined by single-crystal X-ray diffraction. The slightly distorted square planar coordination environment of the platinum metal includes the amino group of the hexamethyleneimine (HMI) molecule and the oxygen atoms of the carboxylato ligand. The cyclobutanedicarboxylic acid (CBDCA) molecule adopts six-member chelating rings with platinum. Hydrogen bonding plays an important part in holding the crystal lattice together.     

Synthese und Struktur der Platin(O)-Verbindungen [(dipb)Pt]2(COD) und (dipb)3Pt2 sowie des clusters Hg6[Pt(dipb)]4 (dipb = (i-Pr)2P(CH2)4P(i-Pr)2)

Synthesis and Structure of the Platinum(0) Compounds [(dipb)Pt]₂(COD) and (dipb)₃Pt₂ and of the Cluster Hg₆[Pt(dipb)]₄ (dipb = (i-Pr)₂P(CH₂)₄P(i-Pr)₂) The reduction of (dipb)PtCl₂ with Na/Hg yields (dipb)Pt as an intermediate which reacts with the amalgam to form the cluster Hg₆[Pt(dipb)]₄ ( 3 ) or decomposes to (dipb)₃Pt₂ ( 2 ) and Pt. In the presence of COD [(dipb)Pt]₂(COD) ( 1 ) is obtained. 1 crystallizes monoclinicly in the space group P2₁/c with a = 1596.1(4), b = 996.5(2), c = 1550.4(3) pm, β = 113.65(2)°, Z = 2. In the dinuclear complex two (dipb)Pt units are bridged by a 1,2-η²-5,6-η² bonded COD ligand. Whereby the C = C double bonds are lengthened to 145 pm. 2 forms triclinic crystals with the space group P1 and a = 1002.0(2), b = 1635.9(3), c = 868.2(2) pm, α = 94.70(2)°, β = 94.45(2)°, σ = 87.95(1)°, Z = 1. In 2 two (dipb)Pt moieties are connected by a μ-dipb ligand in a centrosymmetrical arrangement. 3 is monoclinic with the space group C2/c and a = 1273.8(3), b = 4869.2(6), c = 1660.2(3) pm, β = 95.16(2)°, Z = 4. The clusters Hg₆[Pt(dipb)]₄ have the symmetry C₂. Central unit is a Hg₆ octahedron of which four faces are occupied by Pt(dipb) groups. The bonding in the cluster is discussed on the basis of eight Pt? Hg two center bonds of 267.6 pm and two Pt? Hg? Pt three center bonds with Pt? Hg = 288.0 pm.     

Spectral studies on the interaction of Amido black 10B with DNA in the presence of cetyltrimethylammonium bromide

The interaction of Amido black 10B (AB) with DNA in basic medium was studied in the presence of cetyltrimethylammonium bromide (CTMAB) based on the measurements of resonance light scattering (RLS), UV–vis, CD spectra, and RLS imaging. The interaction has been proved to give a ternary complex of CTMAB–DNA–AB in Britton–Robinson buffer of pH 11.55, which exhibits strong negative Cotton effect at 233.3 nm and 642.8 nm, and strong RLS signals characterized at 469 nm. Experiments showed that the enhanced RLS intensities (ΔI_RLS) against the mixture of AB and CTMAB are proportional to the concentration of fish sperm DNA (fsDNA) and calf thymus DNA (ctDNA), respectively over the range of 0.03–1.0 and 0.05–1.5 μg ml⁻¹, with the limits of determination (3σ) of 7.3 ng ml⁻¹ for fsDNA and 7.0 ng ml⁻¹ for ctDNA.